Barcode/13 is a full software barcode scanner for palmOne Treo600 and palmOne Treo650. Barcode/13 uses the Treo camera to scan ISBN, UPC-A and EAN-13 barcodes and exports the decoded value to the system clipboard. Barcode/13 can be launched within any application, and the returned value can be retrieve from the clipboard to make use of it into the initial application. Barcode/13 is a free alternative to expensive hardware solutions. Barcode/13 can't be seen as a business solution, but it is definitely the cheapest solution for non-business use, like cave, books, CDs or DVDs inventories. Press a long time the 5-way navigation center button to launch Barcode/13. Your Treo will return to the current application when you will leave Barcode/13. If you have confirmed a barcode, the decoded value of your barcode is available in your clipboard and can be copied within any application allowing clipboard manipulations. Press a long time the side button to launch Barcode/13. Your Treo will return to the current application when you will leave Barcode/13. If you have confirmed a barcode, the decoded value of your barcode is available in your clipboard and can be copied within any application allowing clipboard manipulations. Barcode/13 works on palmOne Treo600 and palmOne Treo650, however palmOne Treo600 has a camera measuring the brightness and producing very saturated pictures: due to this, it can be difficult to get a sharp image, sharp enough to recognize the barcode. palmOne Treo650 has a camera that will make it easier to use with Barcode/13. If you don't have a proper contrast with you palmOne Treo600 you can place a sheet of blank paper close to your barcode, this will force the camera to modify the automatic contrast level. During preview mode you can see two red targets and a green line. Green line is the position that will be used to analyse the barcode, targets are recommended sizes for large and small barcodes. Recent barcodes are often large barcodes, but some products have smaller barcodes.

• If you have a large barcode, point your device to fill the large target with your barcode (keep the barcode inside, don't oversize it).
• If you have a small barcode, the small target will be a better idea.
• If your barcode is medium size, something between the 2 targets will be fine.

Barcode/13 will give you best results if you follow some recommendations:

• Your barcode should be lighted without any shade, the easiest way and recommended way is to face the light source.
• Best distance is about 15cm with barcode parallel to your Treo.
• Barcode/13 works best with surfaces like CDs or DVDs, it is possible to use it with bottles but it may require a little training to get the good lighting conditions and to have a symmetric position.
• Don't move your Treo while scanning the barcode: a fuzzy image won't help!

If you don't have a proper contrast in preview mode, for example when scanning a black colored item, you can place a sheet of blank paper close to your barcode: this will force the camera to adjust the contrast level.